Comset DIO-002 Digital 2 Relay IO Board

Description

The DIO-002 digital IO board is designed to allow easy integration of relays to existing hardware. The board lets you switch high voltage or high current loads from LabJack modules, PLCs, microcontrollers and logic circuitry. The relays mounted on the board have the following specifications:

1.5 mm wide isolation slots and a large 14 mm creepage distance between the coil and contact side provide high levels of isolation and protection and allow low voltage circuitry to switch AC power safely.

The driver circuitry has high and low inputs for interfacing to a wide range of equipment.

Dry contact (buttons, switches, other relays), NPN-type outputs, push-pull type outputs and active-low signals connect to the relay card’s Low inputs.

PNP-type outputs, push-pull type outputs and active-high signals connect to the relay card’s High inputs.

A relay is triggered if the Low input is pulled below approximately 0.8 V, or if the High input is pulled above approximately 2.4 V.

The voltage at either input should not be driven below 0 V or above the supply voltage 12 V.

The circuitry for relay draws approximately 2 mA while deactivated and approximately 32 mA when the relay is active.

Wiring:

Connection of Terminal Blocks:

The connection sequence should be accurate. Cable’s insulating striping length is about 7mm. The power cable should be connected correctly. Please double-check before switching the router on. Wrong connections may destroy the equipment.